Manufactured in the UK, the Diginet IP Communicator is a universal IP Communicator. Its ability to traverse even the most awkward NAT networks without a requirement for port forwarding provides for seamless integration of ANY alarm control panel with your Monitoring Centre.
When your alarm panel is behind difficult firewalls or multiple routers - the DigiNet will get through !
The DigiNet is a stand-alone IP adapter that connects to ANY alarm panel to allow sending of alarm signals over the Internet. It uses standard DSL, cable or wireless broadband Internet and connects to the digicom outputs, programmable outputs, relays, or as a last resort - the bell or strobe output of your panel. It differs from all other IP Alarm adapters in that it uses the HTTP protocol to transmit alarm signals.
This means that you will not have to adjust any of the settings in your modem/router in order to get the device working correctly.
Connection to our add-on GPRS board provides a robust dual path solution with both paths fully supervised. The DigiNet can also connect to any panel RS232 port and supports 2-way serial communication. It has 16 digital inputs and outputs, and add-on relay boards are available that allow the remote control ancillary devices. Special interface software is provided to configure the board via a serial port.
Development of version 2 is well under way and due for release in 2010.